06. OPERATION
¯
DANGER of injury as a result of scalding
Always ensure the lid is closed while heating the water; otherwise,
boiling water may spurt out!
Do not open the lid while the water is boiling.
●
●
When filling the kettle, do not exceed the maximum filling level
●
●
(MAX 1.7 L); otherwise, boiling water may spurt out.
Do not bend over the kettle when opening the lid while the content is
●
●
still hot. There is a danger of scalding caused by the escaping steam.
The kettle gets very hot during operation. Only touch it by the handle
●
●
and only operate the unlocking button.
CAUTION! Material damages
Fill the appliance with at least 0.5 l of water; otherwise, the appliance
may overheat.
Drinking water
Water is very sensitive and may spoil due to germ formation. Please observe
the following:
Always use fresh drinking water in the kettle.
●
●
Pour away water which has been in the kettle for more than approx. 1 hour.
●
●
Do not re-boil the water.
●
●
Boiling water
1. Remove the kettle from the base station.
2. Press the unlocking button to open the lid.
3. Fill the desired quantity of fresh drinking water into the kettle. Hold or
place it vertically so that you can properly read the water gauge.
4. Close the lid by pressing it down.
5. Place the kettle on the base.
6. Connect the mains plug to a socket that matches the technical data.
The 100 °C temperature display flashes by default. After 1 minute without
any selection, the display switches off.
7. Use the START/STOP button to switch on the kettle; the START/STOP LED
will light.
8. Select the desired water temperature with one of the temperature setting
buttons
8
. The heating process is started with START/STOP. The tem-
perature LED flashes until the desired temperature has been reached. It
GB
25