Tabla de contenido
Idiomas disponibles
Idiomas disponibles
General warnings
On opening the pack
• Read the instructions carefully before starting installation and proceed as specified by the manufacturer;
• After removing the packaging, check the condition of the unit;
• The packaging items (plastic bags, polystyrene foam etc.) must not be handled by children as they may be dangerous;
General installation instructions
• Installation, programming, commissioning and maintenance of the product must only be performed by qualified technicians who have been properly trained in
compliance with current standards, including health and safety regulations;
• Operate in sufficiently lit areas that are conducive to health and use tools, utensils and equipment that are in good working order;
• The device must be installed in accordance with the IP degree indicated in the technical features;
• If present, do not obstruct the openings or ventilation/heat dispersing holes;
Wiring the devices
• The electrical system must comply with current standards in the country of installation;
• Before connecting the units, check that the indications on the plate correspond with those of the mains;
• Protect units powered with mains voltage using a single pole mains switch with contact separation of at least 3 mm;
• Wires belonging to cables that are not used must be insulated.
• To prevent accidental contact, tighten the mains connection cables and those for the very low voltage signals separately.
• Weld the joints and the ends of the wires to prevent malfunctions caused by wire oxidation;
Installation completed
• When installation is completed, always check for correct operation of the unit and the system as a whole;
• The installer must check that the information required by the user is present and handed over;
Maintenance
• Before performing any cleaning or maintenance operation, disconnect the power supply to the device. If the units are mains-powered, disconnect the power using
the switch upstream from the units;
• In the case of device failure or malfunction, disconnect it from the power supply and do not tamper with it;
• Should the unit be in need of repair, contact only a technical support centre authorised by the manufacturer and always use spare parts provided by CAME S.p.A.
The units must only be used for the purpose for which they were explicitly designed.
Failure to follow the instructions provided above may compromise the unit's safety.
The manufacturer declines all liability for any damage as a result of improper, incorrect or unreasonable use.
DISPOSAL
Do not litter the environment with packing material: make sure it is disposed of according to the regulations in force in the country where the product is used.
When the equipment reaches the end of its life cycle, take measures to ensure it is not discarded in the environment.
The equipment must be disposed of in compliance with the regulations in force, recycling its component parts wherever possible.
Components that qualify as recyclable waste feature the relevant symbol and the material's abbreviation.
Packaging contents
EN
Allen wrench
ACCESSORIES (to be purchased separately)
001DC00EGMA11 Single button
001DC00EGMA12 Single button and
double height
001DC00EGMA13 Double button
2
Dimensions
Audio/video entry control
2 plugs and
2 screws with washer
LTP Wall roof
99
30
99
30
001DC00PLACO02 Recessed frame
6.5
6.5
135
135
3.5
3.5
001DC00PLACO03 Recessed box
Tabla de contenido
