To Assemble The Upper Handle - Powermate PM2015 Manual De Uso

Assembly
(Continued)
• Save all instructions

TO ASSEMBLE THE UPPER HANDLE

Recoil Handle
Rope Guide
TO ASSEMBLE THE BLADE CONTROL ASSEMBLY
1. Insert the T-Bar pin into the Bracket as shown in Figure 6.
NOTE: It may be necessary to temporarily remove the
pre-assembled cable clip from the upper handle, to get
enough slack in the cable. Reassemble the clip after the
pin is inserted.
2. Secure the cable to the upper handle with the cable clip
(item 8). See Figure 7.
3. Insert the opposite side (left) end of the blade control
lever into the hole in the upper handle. See Figure 5.
IMPORTANT: After completing these steps, pull the Blade
Control Lever down against the upper handle. This should
actuate the spring loaded brake lever on the engine. The
Blade Control Lever should spring back to the upper posi-
tion when released.
WARNING
The Blade Control Assembly is required to be able to stop
the engine and brake the blade. Never run the lawn mower
without the Blade Control Assembly correctly assembled.
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or have any questions,
CALL TOLL FREE: 1-800-737-2112.
Item numbers in assembly instructions and figure correspond
to parts list on page 9.
1. Place the upper handle (item 13) in position over the
lower handle (item 14). See Figure 5.
2. Insert the round head, square neck bolts (item 3)
through the holes in each side of the upper and lower
handles, and secure with the large wing nuts (item 10).
3. Pull the recoil starter and thread the rope through the
rope guide, as shown in Figure 5.
Figure 5
Blade Control
Lever
ENG - 11
T-Bar Pin
Bracket
Pre-assembled
Cable Clip
Copyright © 2016 MAT Engine Technologies, LLC
Figure 6
Figure 7