Tabla de contenido
Idiomas disponibles
Idiomas disponibles
MITER GAUGE
OPERATION
AND ADJUSTMENT
MAKE CERTAIN the table saw is disconnected from
the power source when making adjustments.
Figure
27=1
C
E
1.
The miter gauge has adjustable positive stops at
O-degree and plus or minus 45-degrees or it can be
manually set at any angle between plus or minus
60-degrees.
2.
To rotate miter gauge body (A), loosen knob (B) and
pull out plunger (C) and rotate miter gauge body to
desired angle and tighten knob. See figure 27-1.
3.
To rotate to the next positive stop pull plunger out,
rotate miter gauge body then push plunger back in
and continue rotating miter gauge body until it stops
against next positive stop.
4.
To adjust O-degree positive stops, loosen knob, pull
out on plunger and turn miter gauge over.
Figure
27=2
G
D
5,
6.
Loosen the lock nut (D) 3 or 4 turns. See figure 27-2.
Place a square against the guide bar (E) and front
of the miter gauge body (F). Square the miter
gauge body to the guide bar and tighten knob.
See figure 27-1.
7.
Push in plunger and make adjustments to stop
screw (G) so that it touches the plunger and tighten
lock nut. See figure 27-2.
8.
Recheck the positive stop angle to the saw blade.
Insert the guide bar into the miter gauge groove
and slide the miter gauge up to the saw blade.
9.
To check, place a square against the saw blade
and miter gauge body. If any more adjustments are
need repeat steps above.
10. To set both 45-degree positive stops, repeat steps
above.
CLAMP
AND FENCE STOP OPERATION
MAKE CERTAIN the table saw is disconnected from
the power source when making adjustments.
Figure
28=1
E
B
C
\
D
1.
The stock clamp (A) can be positioned in and out
by loosening the two knobs (B) and sliding the
clamp body in or out. Retighten knobs when at
desired position.
See figure 28-1.
2.
The stock clamp has a quick release allowing you
to quickly position the clamp up or down. To
engage quick release press up on trigger (C) and
hold. The clamping pad (D) will fall or it can be
lifted. To release let go of the trigger.
Now you
can turn knob (E) to apply clamping pressure.
See figure 28-1.
3.
The fence stop (F) can be reposition along the
fence by loosening the hex socket head screw (G).
Slide the fence stop to desired position and tighten
hex socket head screw. If the fence stop is not
needed, it can be stored out of the way on the
backside of the fence. See figure 28-1.
34
Tabla de contenido
