Toshiba MMY-MAP0501HT8-E Manual Del Propieratio página 14

5
ADJUSTMENT OF WIND DIRECTION
K
4-way Air Discharge Cassette, 1-way Air Discharge Cassette (2SH series),
Under CeilingType
1
n How to set up the wind direction
1
SWING/FIX
Push during operation.
The wind direction changes for every push of the
button.
[In HEAT operation
(For Heat-pump model only)]
Direct the louver (adjustment plate of up/down wind
direction) downward.
If directing horizontally, hot air
may not come to the foot.
[In COOL/DRY operation]
Direct the louver (adjustment plate of up/down
wind direction) horizontally.
If directing it downward, the dew
may form on the surface of the air
discharge port and may drop down.
[In FAN operation]
Select a desired wind direction.
n How to start swinging
1
SWING/FIX
Push , set the louver (adjustment plate
of up/down wind direction) direction to the
lowest position, and then push
SWING is displayed and the up/down wind
direction is automatically selected.
Display during swinging
English-13
FILTER L LTER
RESET TEST
Initial setup
Initial setup
Initial setup
SWING/FIX
again.
Repeat
TIMER SET FAN
TIME SAVE AVE A
SET CL SWING/FIX UNIT LOUVER T
n How to stop swinging
1
SWING/FIX
Push
louver is swinging.
SWING/FIX
• When
can be set again from the highest position.
∗ However, even if
louver is swinging, the louver position is
displayed as follows and highest position of the
louver may not be selected.
Display when swinging is stopped
In this case, push
• In COOL/DRY operation, the louver does not
stop as it directs downward. If stopping the
louver as it directs downward during swing
operation, it stops after moving to the third
position from the highest position.
Display when stopping the swing
Unit select button
• When multiple indoor units are controlled with one
remote controller, wind direction can be set for each
indoor unit by selecting individually.
• To set wind direction individually, push
to display an indoor unit number in the control group.
Then set the wind direction of the displayed indoor unit.
• When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
• Each time you push
changes as follows:
Unit No. 1-1
13
MODE
VENT
Unit select button
at a desired position while the
is pushed after that, wind direction
SWING/FIX
is pushed while the
FAN/HEAT
operation
SWING/FIX
again two seconds later.
FAN/HEAT
operation
UNIT LOUVER
UNIT LOUVER
button, the display
Unit No. 1-2 Unit No. 1-3
No display Unit No. 1-4
COOL/DRY
operation
COOL/DRY
operation
button