Ezviz T9 Guia De Inicio Rapido página 6

• Option 2 Adding by Operating the Internet Alarm Hub
1
Enable the "Adding Detectors Mode" of your Internet Alarm Hub. Refer to Quick Start Guide of your
Internet Alarm Hub for details.
2
Take T9 close to the Internet Alarm Hub (within 50cm) and press the button on T9, the red indicators
flicker once indicating the adding signal is sent.
3
The Internet Alarm Hub issues a voice prompt of the device type and serial No. indicating T9 is added.
4
You can test the device after the installation.
- Press the Emergency button on the remote control of the Internet Alarm Hub to trigger an emergency
alarm. If the T9 starts to alarm, it has been added to the Internet Alarm Hub successfully.
- Press the Mute button on the remote control of the Internet Alarm Hub to clear the alarm. And then the
T9 will stop alarm.
Internet Alarm Hub
Setting Button
2