Ezviz T9 Guia De Inicio Rapido página 7

Option 2 Adding by Operating the Internet Alarm Hub
1
1 Enable the "Adding Detectors Mode" of your Internet Alarm Hub. Refer to Quick Start Guide of your
Internet Alarm Hub for details.
2 Take T9 close to the Internet Alarm Hub (within 50cm) and press the button on the T9, the red
indicators flicker once indicating the adding signal is sent.
3 The Internet Alarm Hub issues a voice prompt of the device type and serial No. indicating T9 is
added.
4 You can test the device after the installation.
- Press the Emergency button on the remote control of the Internet Alarm Hub to trigger an
emergency alarm. If the T9 starts to alarm, it has been added to the Internet Alarm Hub
successfully.
- Press the Mute button on the remote control of the Internet Alarm Hub to clear the alarm. And
then the T9 will stop alarm.
Internet
Alarm Hub
Setting Button
3