Alarm Function; Snooze Function - PTB 609 Manual De Instrucciones

P.9
Important
• It is recommended to put the Atomic Clock near a window facing Mainflingen. Please move the clock to another location
if difficulty in signal reception is encountered.
• Press the "Reset" button when the clock is displaying irrelevant time even when the "Wave OK" shows on the LCD. This
may happen when the external noise is severe enough to interfere with the time signal.
To Set Alarm Time and Activate Alarm Function
1. Press MODE button to enter alarm setting mode
2. Press Month / Hour / Wave button or Date / Min / 12 / 24 / Language button to set time.
3. Press Year / Sec /Alarm / °C / °F button can toggle between alarm off, alarm on and snooze function. The LCD screen
will display " " for alarm on function and both "
4. Press MODE button to confirm whole setting.
* If no key is pressed for 10 seconds in any of the above step, it will automatically quit the setting mode and a 'beep'
sounds out.

Alarm Function

• If alarm function is activated, alarm will ON for a minute until SNOOZE/LIGHT button is pressed. The alarm will sound
the same time of next day.

Snooze Function

• If snooze function is activated, alarming sound will ON for a minute. If SNOOZE/LIGHT button is pressed, alarm will
sound again 4 minutes later.
• If MODE button is pressed during snooze alarm, snooze will be deactivate and will sound again in the same time of next
day.
To Select °C or °F Temperature Reading
• Press Year / Sec /Alarm / °C / °F button to choose your design temperature reading.
Using the Superglow Backlight and Projector
• You may check the time in the dark by simply pressing the SNOOZE/LIGHT button once. The display will light up with a
soft glow that lasts for a while. You can read the time easily and clearly. If the clock is receiving atomic signal, backlight
will not function until the end of reception.
• Adjust by turning forwards or backwards the projector, so that the projection lens is pointed in the appropriate direction.
• Focuses image - rotate PROJECTOR FOCUS dial at the right side of the clock forwards or backwards until the image
clarity is optimized.
Note: Frequent use of this feature will affect battery life.
"ALWAYS-ON" Full Color Projection and LCD Backlight
• The clock is equipped with an "Always-On" (continuous) projection and backlight LCD feature.
• Once ALWAYS BRIGHT is switched on, both wall projection and backlight will be activated continuously, in sequence of
Red > Blue > Green with slow fading interchange. Each period will last for about 8-12 seconds.
• When the clock is receiving atomic signal, both projection and backlight will stop color changing and keep in blue color
until the end of signal receiving.
• The "Always-On" projection and backlight feature can only be activated when the adapter is plugged into an outlet.
• If Always-On is activating, pressing SNOOZE/LIGHT button will not change the lighting effect of the wall projection and
backlight.
" and "Zz" for snooze function.