THERMEx Top Link Modul I Instrucciones página 69

M 536991200913062017
CONNECTION OF THE RECEIVER ON THE HOOD'S CIRCUIT BOARD
The receiver is mounted on the circuit board to the hood. The receiver is connected to the connector for the control panel in the following way:
1
Set the receiver on the connector for the
control panel.
In order for Top Link to control the hood's functions, it is important that the circuit board on the hood is set correctly. The dip switches for the control
panel must be set as follows:
NOTE: If the dipswitch settings are changed, the power must be disconnected from the circuit board before the settings are saved.
2
THERMEX TOP LINK MODUL
3
NOTE: If there is a control panel on the hood,
connect this to the receiver.
69