Trial Run - Ibx HM01 Manual De Usuario

5. Trial Run

Make sure the required operating voltage and the power supply voltage match.
•
Ensure the socket is properly earthed.
•
Ensure the power is OFF.
•
Pour the liquid to be heated in a vessel; if a stirring mantle is going to be used put a magnetic
•
stirring rod inside the vessel.
Put the vessel on the working space.
•
Plug in the power cable and ensure the power is ON.
•
Set the desired temperature; the equipment will start working.
•
Observe the real temperature.
•
In the models with stirring (HM02 series), select the stirring speed.
•
Check the stirring rod.
•
Stop the heating and stirring functions and power OFF the equipment.
•
If the operations above cause no abnormalities, the device is ready to operate. Otherwise, the device
may have been damaged during transportation. In that case, please contact your supplier.
6. Operation
6.1 Heating Mantle, HM01 series
Put the heating mantle on top of a horizontal, flat, and stable table leaving at least 30 free cm
•
on each side. Do not place it near any heat source.
Plug the equipment into a power source; the red pilot (1) will light up showing that it is
•
connected to the power and will stay lit whenever the equipment is connected to a power
source.
Turn the temperature knob (2) clockwise until you hear a "click"; this shows the heating mantle
•
is ON. To adjust the temperature, keep turning the knob clockwise.
Green pilot (3) – Working – shows the temperature variation. Thus, the more intense the light is,
•
the higher the temperature of the sample is.
Placing the thermometer: Assemble the two parts of the rod and insert the rod in its support at
•
the back side of the equipment. Once the rod is placed, place the bosshead at the desired
height, hold it with the screw and place the thermometer clamp.
7