Idiomas disponibles
Idiomas disponibles
User Guide
IMPORTANT! READ AND FOLLOW
THESE INSTRUCTIONS CAREFULLY AND
KEEP FOR FUTURE REFERENCE.
Congratulations on the purchase of your new
Nomi Baby, developed for the needs of your
infant. We believe that family meal time is
special; conversation, socialization, and special
moments all occur around the dining table. With
your new Nomi, you've made sure that everyone
is included, even the youngest family members!
Nomi Baby is approved for babies up to 20 lb (9
kg) or when baby starts trying to sit up, which-
ever comes first.
Assembling Nomi Baby
Please find an assembly video at
www.evomove.com or on our YouTube channel.
In order to use the Nomi Baby, you have to have
the Nomi High Chair.
The Nomi High Chair base is assembled with 4 of
the 6 supplied screws (G), using one of the 2 small
Allen wrenches (I2) you find stored under the
footrest, plus the large Allen wrench (I1) you find
in the hardware bag attached to the bases (C).
IMPORTANT! Always use the supplied
TufLock® coated screws as they provide a
necessary strong grip. They are a little tough
to tighten, but once done they don't need to be
re-tightened as often.
Assemble on a level surface and start by at-
taching the base as shown in Figure 1 on page
1. Insert the long metal tube (H1) into the inside
bottom hole in one base and the short tube
(H2) into the top hole of the same base. Slide
the metal tubes into the wood stem (A) with the
wheel pointing backwards and then slide the
3
Brugervejledning_Baby_US_18.indd 3
second base on. Insert 4 screws and use two
Allen wrenches to tighten the base to the stem.
Hold one screw with the small Allen wrench,
tighten the screw on the opposite side with the
large Allen wrench. Repeat on the second set
of screws. Insure there is no gap between the
stem and the bases. Tighten and re-tighten
all screws from both sides until all 4 screws
are secure. Retighten the screws 2-3 weeks
after assembly and when necessary.
Next, attach the Nomi Baby to the wooden stem
with the 2 screws supplied (G), using the small
Allen wrench.
IMPORTANT! The adjustment knob (F) needs
to be carefully attached to the bolt on the Nomi
Baby. Prior to shipping, it is attached, inspected
and correctly threaded.
Unscrew the adjustment knob, remove the
plastic washer (E), and insert the bolt and the
safety slide (D) back through the track in the
stem. Place the washer back on the bolt with
the groove facing out, and very carefully thread
the knob onto the bolt using only your fingers.
Make sure it threads correctly. DO NOT use
force until you feel it is threaded correctly. If
need be, back it out and try again.
Adjusting Nomi Baby Angle
By loosening and tightening the adjustment
knob under the Nomi Baby, you can adjust it
seamlessly from almost horizontal to more
upright positions, to meet your child's needs,
Figure 2 on page 2.
23/07/2018 12.07
