ELICA ESN130 Guía De Instrucciones Para Instalación página 12

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

For non-vented (recirculating) installations:
The charcoal filter is not washable. It should last up to 6 months
with normal use.
1. Replace metal grease filter with a charcoal filter. For
information on ordering, see the "Accessories" section.
To replace filter:
Remove screw from the grease filter retainer.
1.
2.
Turn the grease filter retainer to release filter.
Reinstall the filter by placing the back edge in the channel at
3.
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
REPLACE THE INCANDESCENT LIGHT BULB
(ESN130, EFS130 & ERS230 SERIES MODELS)
Turn off the range hood and allow the light bulb to cool.
Disconnect power.
1.
2.
Squeeze the plastic lens cover and remove it from the hood.
Screw a new 120v 75W (maximum), A19 light bulb into
3.
socket.
NOTE: In two lamps ERS models, use two 40W light bulbs
instead of 75W.
Replace lens cover by squeezing cover and inserting tabs
4.
into slots.
A. Light bulb socket (A19)
B. Lens cover
5.
Reconnect power.
If new light does not operate, make sure the lamp is inserted
6.
correctly before calling service.
B
A
REPLACING THE HALOGEN LAMP (ENM230 &
ENM236 SERIES MODELS)
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1.
Disconnect power.
Push up on the lens and turn it counterclockwise.
2.
3.
Remove the bulb and replace it with a 120-volt, 50-watt
maximum halogen bulb with a GU10 base.
Turn it clockwise to lock it into place.
4.
Repeat steps 2-3 for the other bulbs if needed.
Reconnect power.
5.
12
Tabla de contenido
loading

Tabla de contenido