GHP Group Pleasant Hearth OFG467T Manual De Instrucciones página 11

ASSEMBLY INSTRUCTIONS
4. Attach the back panel (E) to the left and right side
panels (G, D) with four M6X12 bolts (AA).
Tighten with screwdriver (GG).
Hardware Used
AA
Bolt M6 x 12
GG
Phillips screwdriver
5. Find the spindle at the bottom of the door (M).
Insert it into the hole on the bottom plate (H). Insert the
top spindle of the door (M) into the hole on the door
bracket (L) as pictured. Hold the door (M) in place as
you attach the door bracket (L) to the left and right
side panels (G,D) with four M6 x 12 bolts (AA). Make
sure to adjust the gap between the door (M) and door
bracket (L) to make it even when tightening the bolts.
Do not put door bracket (L) too close to the door (M)
to ensure that it can open easily. Tighten with Phillips
screwdriver (GG).
Hardware Used
AA
Bolt M6 x 12
GG
Phillips screwdriver
6. Line up the holes on the table (C) with the screw
holes on the left and right side panels (G, D).
Insert four M6X12 bolts (AA) through the
holes. Tighten with Phillips screwdriver (GG) and
wrench (FF).
Hardware Used
AA
Bolt M6 x 12
FF
Wrench
GG
Phillips screwdriver
4
X 4
5
L
M
X 4
6
X 4
11
G
AA
AA
G
C
G
AA
C
G
E
D
D
H
D