Assembly Instructions - GHP Group Pleasant Hearth OFG467T Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Attach the door handle (N) to the door (M) with two
M4X6 screws (CC) and two washers ø4 (EE). Tighten
with screwdriver (GG).
Hardware Used
CC
Screw M4 X 6
EE
Washer ø4
GG
Phillips screwdriver
2. Attach the gas cylinder belt (F) to the back panel (E)
with two M4X8 screws (DD). Tighten with screwdriver
(GG).
Hardware Used
DD
Screw M4 x 8
GG
Phillips screwdriver
3. Position the right side panel (D) on the bottom plate
(H) on the side with the door mounting hole. Attach the
left and right side panels (G, D) to the bottom plate (H)
with four M6X12 bolts (AA) as shown on figure 3. Make
sure to use the parallel holes when mounting the side
panels. Do not use the door mounting hole. Tighten with
the screwdriver (GG) and wrench (FF)
Hardware Used
AA
Bolt M6 x 12
FF
Wrench
GG
Phillips screwdriver
1
X 2
X 2
2
X 2
F
F
3
X 4
10
M
M
E E
G
H
AA
EE
CC
N
N
DD
D
Door
mounting
hole