Tabla de contenido
Idiomas disponibles
Idiomas disponibles
I N S T R U C T I O N S F O R U S E
P R I O R T O U S E
Plug the power adapter into the unit's Power Adapter Socket and the other end into a household
electrical outlet. The blue/white energy level indicator lights will flash on and turn off; the green status
light will begin flashing.
S P O T T E S T
The spot test is intended to determine your skin's reaction to the AFT/IPL treatment and help you
select the optimal energy level for each treatment area. Do a spot test on each area you intend to
treat 48 hours prior to the full treatment.
1. Prior to use, make sure your skin is shaved, clean and dry (free of any residue such as powders,
creams, make-up, antiperspirants or deodorants).
WARNING: NEVER use flammable liquids such as alcohol or acetone to clean the skin before
using the IPL device.
2. Set up the device following the instructions above.
3. Place the applicator treatment window on the required test area with full contact to the skin.
4. The device sets itself on the lowest energy level. Deliver the first pulse, on energy level 1, by
pressing the pulse button. You will see a bright flash, hear a popping noise and you may feel a mild
stinging or/and heat sensation.
5. Remove the applicator from the skin and place it on the next spot of the test area.
6. Use the power button to increase the energy level by 1. The energy level lights will light up blue
(or white for levels 4 and 5) according to the selected energy level. Deliver the second pulse, on
energy level 2, by pressing the pulse button.
7. Only if you feel comfortable repeat steps 5 to 6 until you have reached the maximum energy Level
of 5. Stop the test once you do not feel comfortable, increasing the energy level increases the
risk of adverse effects. If you see adverse effects such as severe redness or blistering stop the
test immediately.
8. Wait 48 hours and examine the tested area. If the skin in the test area seems normal (no response
or mild redness) you can proceed with a full treatment in the highest comfortable energy level you
tested. If you see extreme redness, swelling or blistering, even in the low energy level settings do
not do the full treatment in that area.
Note: Do not treat full areas in energy levels you have not tested before.
Do not treat the tested area for at least 1 week after the spot test is done. Use the table below to
make a note of the energy level that suits you for different areas you wish to treat.
12
Body Area
Comfortable Energy Level
13
Tabla de contenido
