Problem
Possible cause & Solution
Check whether the power cord is plugged into the power outlet
properly.
Check whether the "Power" function is on by pressing the
"power" button for 1 second.
Check the fuse or circuit of your power supply, replace if
Appliance is not
necessary.
working correctly
The ambient temperature is too low. Try setting the chamber
temperature to a colder level to solve this problem.
It is normal that the refrigerator is not operating during the
automatic
appliance is switched on to protect the compressor.
The interior may need to be cleaned.
Odours from the
Some food, containers or wrapping cause odours.
compartments
The sounds below are quite normal:
Compressor running noises.
●
Air movement noise from the small fan motor in the fridge
●
compartment or other compartments.
Gurgling sound similar to water boiling.
●
Popping noise during automatic defrosting.
●
Noise from the
Clicking noise before the compressor starts.
●
appliance
Other unusual noises are due to the reasons below and may
need you to check and take action:
The cabinet is not leveled.
●
The back of appliance touches the wall.
●
Bottles or containers have fallen or are rolling.
●
It is normal to frequently hear the sound of the motor, it will
need to run more when in following circumstances:
Temperature setting is set colder than necessary
●
Large quantity of warm food has recently been stored within
The motor runs
●
the appliance.
continuously
The temperature outside the appliance is too high.
●
Doors are kept open too long or too often.
●
After you installed the appliance or it has been switched off
●
for a long time.
Check that the air outlets are not blocked by food and ensure
A layer of frost
food is placed within the appliance to allow sufficient ventilation.
occurs
in
the
Ensure that door is fully closed. To remove the frost, please
compartment
refer to cleaning and care chapter.
You may have left the doors open too long or too frequently; or
Temperature
the doors are kept open by some obstacle; or the appliance is
inside
is
too
located with insufficient clearance at the sides, back and top.
warm
defrost
cycle,
or
for a short time after the
20