Loose Parts; Installing The Auxiliary Handle - Toro 51484 Manual Del Operador

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1

Installing the Auxiliary Handle

Parts needed for this procedure:
1 Auxiliary handle
1 Latch
1 Brace
1. Position the auxiliary handle on the shaft of the trimmer with
the smooth surface facing the operator (Figure 1).
1. Auxiliary handle
2. Latch
2. Slide the brace into the auxiliary handle so that the brace
rests in the groove along the shaft (Figure 1).
Description
Auxiliary handle
Latch
Brace
Guard
Phillips head screw
Wire edge guard
No parts required
G017277
Figure 1
3. Brace
Qty.
1
1 Installing auxiliary handle.
1
1
Mounting the guard to the base of the
trimmer.
1
1 Installing the edge guard
–
3. Slide the latch from the left through the handle and brace
as shown and tighten the latch screw with a Phillips head
screwdriver (Figure 1).
5
Use