Installation Instructions - Electrolux EFME427UI Instrucciones De Instalación

Water connection, continued
(Steam Model only)
Rubber Washer
Must be Present
and Undamaged
Cold Inlet Hose
to Washer
3. Momentarily turn on COLD supply
and run some water into a bucket or
container to clear any contaminants in
the line.
4. Inspect hose couplings for proper
placement of rubber washers. Use
hoses from
ASSEMBLY HOSE KIT
5304495002 (not included).
Rubber Washers
MUST BE PRESENT
Hose Extension
"Y" Connector
Cold Water Supply
Hose to Washer

Installation Instructions

5. If your installation has room for the
If you were able to install the "Y" connec-
tor directly to the COLD water supply,
please skip to step 8.
6. If there is not room to install the "Y"
7. Thread the "Y" connector to the short
8. Connect the COLD inlet hose for the
9. Connect the straight end of the long
#
10. Turn on the water and check for leaks
Water Inlet
on Dryer
COLD water supply to accept the "Y"
connector directly, thread the "Y" con-
nector to the COLD water supply and
snug it by hand; then tighten it another
2/3 turn with pliers.
NOTE
connector directly, thread the short
extension hose on to the COLD water
supply and snug it by hand; then
tighten it another 2/3 turn with pliers.
extension hose and snug it by hand;
then tighten it another 2/3 turn with
pliers.
washer to the "Y" connector and snug
it by hand; then tighten it another 2/3
turn with pliers.
hose from the kit to the other outlet
on the "Y" connector and snug it by
hand. Connect the hose's 90° cou-
pling to the brass water inlet on the
back of the dryer and snug it by hand.
Tighten each connection of the dryer
inlet hose another 2/3 turn with pliers.
at all connections.
17