Uline H-4026 Manual De Instrucciones página 3

Telescoping handle and wheels are available on H-4027
model. (See Figure 6)
To use handle, push in release button, pull handle up until
it locks into place. Tilt the unit back onto the wheels and
roll to desired location.
WARNING! To reduce the risk of fire, electric
shock or injury; DO NOT attempt to service the
unit while appliance is plugged in.
PERIODIC MAINTENANCE
1. Check power cord for any breaks, separations
or cuts.
2. Make sure the ground pin or grounding prong is
intact or the machine will be unsafe to operate.
IF THE BLOWER WILL NOT RUN:
1. Check electrical cord. Ensure is it firmly seated in
wall outlet.
2. Check GFCI and reset if tripped.
OPERATING ISSUE
Blower not running.
Blower vibrates.
For any problem not listed above, call a qualified Sanitaire repair center for service information.
PAGE 3 OF 12
OPERATING CONTINUED
MAINTENANCE
4. Never clean the portable blower with water directly.
TROUBLESHOOTING
3. Check to see if building circuit breaker is tripped. If
4. Motor overheated and tripped thermal protection;
CAUSES
No power input.
Switch not turned on.
Fan wheel jammed.
Intake or exhaust blocked.
Accumulation of dirt on fan blades.
Figure 6
3. To keep the portable blower clean, use a damp
cloth to wipe the surface of the housing.
5. When not in use, unplug and store the portable
blower in a dry indoor place out of reach of
children.
circuit is overloaded, move cord to different GFCI outlet.
turn off and unplug. Wait 30 minutes to let cool
before running.
RECOMMENDATIONS
Plug in and check circuit breaker.
Turn on switch.
Remove material jamming fan wheel.
Turn unit off and allow to cool,
then remove blockage.
Clean fan blades.
0815 IH-4026