Test The Safety Reversal System; Test The Protector System - LiftMaster Premium Serie Instrucciones De Uso

Adjustment
2

Test the Safety Reversal System

Without a properly installed safety reversal system,
persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door.
• Safety reversal system MUST be tested every month.
• After ANY adjustments are made, the safety reversal
system MUST be tested. Door MUST reverse on
contact with 1-1/2" high (3.8 cm) object (or 2x4 laid
fl at) on the fl oor.
2.1
With the door fully open, place a 1-1/2 inch
(3.8 cm) board (or a 2x4 laid fl at) on the fl oor,
centered under the garage door.
2.2
Press the remote control push button to close
the door. The door MUST reverse when it makes
contact with the board.
If the door stops but does not reverse:
1. Review the installation instructions provided to insure
all steps were followed; 2. Repeat Program the Travel (see
Adjustment Step 1); 3. Repeat the Safety Reversal test.
If the test continues to fail, call a trained door systems
technician.
3

Test the Protector System

Without a properly installed safety reversing sensor,
persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage
door.
3.1
Open the door. Place an obstruction in the path of
the door.
3.2
Press the remote control push button to close the
door. The door will not move more than an inch
(2.5 cm), and the garage door opener lights will
fl ash 10 times.
The garage door opener will not close from a remote
control if the LED in either safety reversing sensor is off
(alerting you to the fact that the sensor is misaligned or
obstructed).
If the garage door opener closes the door when the safety
reversing sensor is obstructed (and the sensors are no
more than 6 inches [15 cm] above the fl oor), call for a
trained door systems technician.
®
13