Tabla de contenido
Idiomas disponibles
Idiomas disponibles
plug the AC adapter into the AC power Jack on the back of your phone,
then into a standard electrical outlet or surge protector, if you are
using one. For safety reasons, use only the AC120v DC9v 200mA
adapter provided.
Note: The adapter is required for the telephone to work correctly.
Hanging The phone on The Wall
You can place your phone on a flat surface or mount it on a telephone
wall plate (not included).
To mount using an existing wall plate adapter.*
1 Connect one end of the short phone cord to the telephone wall
plate and the other to the telephone
2 Insert the supplied mounting bracket (the 3 ¾" x 1 ½" rectangle
included with your phone) into the slots on the back of the phone
and push the bracket up until it clicks. The keyhole opening should
match the direction of the one above it. To detach the bracket,
simply depress the tab with a pen, Screwdriver, etc. to allow the
bracket to slide down.
3 Insert the two keyhole slots on the phone with the wall plate and
slide the phone down, being careful not to pinch the telephone
line, until the phone is secure.
4 press and lift out the handset holder. Remove the hanging peg
(located by the switch hook) by pushing it upwards then rotate
the peg 180 degrees, then snap it into place so it will hold the
handset in place when the phone is mounted on the wall.
*If you do not have an existing wall plate adapter, they are available
for purchase at most major electronic retailers or home improvement
centers. Follow the manufacturers' instructions for installation.
press the MENU button. The display shows LCD CONTRAST.
press the DIAL button. The display shows the current contrast setting
with values between 1 and 5.
press
or
to select the contrast level and confirm with DIAL button.
The display now shows to ENTER TIME/DATE, you can refer to next
section to set the time and date or press
up mode.
Connecting The power Supply
Setting The Contrast
SET Up
5 – ENGLISH
button to exit the set-
Tabla de contenido
