Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.1 User code self-learning process
The pushbutton "RST" of the Rolling-Code reception control unit enables activation of the user code self-learning process: in this way it is able to recog-
nise only RollingCode radio controls with an ID (Serial Number) previously entered in the recognition table in its internal memory. The control unit enables
memorisation of up to 500 users.
5.2 Transmitted code self-learning procedure
- Briefly press the key LRN ; in this case the LED remains lit on standby for receiving a new code from the first or next radio control;
- press the pushbutton PLS 1 of the radio control to be memorised in the receiver; after a brief interval the LEDLRN turns off, to confirm memorisation of
the radio control code.
If no radio control code memorisation operation is performed, after approx. 18 seconds, the LED LRN turns off indicating automatic exit from the self-learn-
ing process.
PLS 1
PLS 2
6. Parameters / Configuration programmable by means of programmer 950B
The Rolling-Code receiver control unit envisages the option of programming by means of programmer Art.950B: this enables updates to the operating
mode of the four relays and operations to add or delete codes/radio controls.
Programmable parameters:
- for each relay: mode (bistable/monostable), timer scale (sec/minutes/tenths of minutes) and the contact timer value;
- mode of intervention on transmitter code;
- physical location in which operation is to be performed (deletion, writing, etc.);
6.1 Function settings
The insertion of the ELVOX programmer type 950B, by means of the relative cable for plug connection, enables programming of the operating parameters
of the four relays available on the receiver; these can be programmed to activate commands according to the functions associated between the radio con-
trol key and the relative relay activated on the receiver.
Note: after insertion of the programmer by means of the telephone plug cable wait for the LED LRN to turn off (after approx. five seconds) before proceeding with programming.
On connection of programmer 950B, by means of the connection cable to the plug socket of the
receiver, after a few seconds the displays shows the following message:
Use key
of the programmer to select the programming menu:
and press .... to confirm
: this operation sets the receiver board to the programming status (indicated by continuous flashing of the LED LRN ) , when
key
is pressed again this confirms start-up of the parameter programming procedure and the programmer display shows:
To select and modify the parameters related to the access password, activation mode of the four relays on the receiver (A, B, C and D) or memorisation of
the radio control codes, simply press the key
to set the required value according to the ranges of significant values for the parameters described above and then press
value and move on automatically to the next parameter. To exit parameter programming mode press
ceiver board.
EN
ELVOX
950B
<< PLUG >>
PROGRAM. PARAM.
P g m . T e c n i c a
ECR1
o
repeatedly to scroll through the list of parameters described above and use the numerical keypad
PRG
and then disconnect the programmer from the re-
o
to confirm the entered
7
Tabla de contenido
