Delay Start; Intensive Drying - Bosch SGE63E UC Serie Manual De Uso

InfoLight
(model dependent)
An LED illuminates the loor to indicate the unit is running. Do not open the dishwasher door until the LED is no longer visible
on the loor. If the appliance is installed at eye-level, the LED is not visible.
To change the setting:
• Turn unit on by pressing the [
• Hold down the "A" button (see page 4) and press [
• Release both buttons.
The LED for "A" lashes and display indicates "H:04".
•
• Press the "A" button until the display shows "1:01".
• Press the "C" button to switch between "1:01"= ON and "1:00" = OFF and press [

Delay start

You can delay the start of the cycle in one hour increments up to 24 hours.
• Open the door (for hidden controls only).
• Turn unit on using the [
• Press [+] until the display jumps to "h:01".
• Press [+] or [–] until the displayed time corresponds with your requirements. "h:01" = 1 hour delay "h:24" = 24 hour delay
• Press [ ]. Delay start is activated.
START
• Press the [+] or [–] button until "h:00" is indicated on the digital display.
You can change your selection at any time until the program starts.
• Close the door (for hidden controls only).
Cycle Completion Signal (hidden controls only)
The cycle completion is indicated by a tone. This function can be changed as follows:
• Open the door .
• Turn unit on using the [
• Hold down the "A" button (see page 4) and press [
• Release both buttons.
• Press the "A" button until the display shows "b:02".
• Press the "C" button to increase or decrease the tone. "b:00" = of and "b:03" = loudest
• Press [ ] to save the setting.
START
• Close the door.

Intensive drying

The inal rinse uses a higher temperature which improves the drying result.
The running time may increase slightly. (Use caution if utensils are delicate!)
• Open the door (for hidden controls only).
• Turn unit on using the [
• Hold down the "A" button (see page 4) and press [
• Release both buttons.
• Press the "A" button until the display indicates "d:00".
• Press the "C" button to turn intensive drying on or of. "d:01" = ON or "d:00" = OFF
• Press [ ] to save the setting.
START
• Close the door (for hidden controls only).
Auto Power Of
To save energy, the dishwasher is turned of 1 minute after the wash cycle ends. Auto Power Of can be adjusted from P:00
to P:02.
To change the factory setting (P:01):
• Open the door (for hidden controls only).
• Turn unit on using the [
Hold down the "A" button (see page 4) and press [
•
• Release both buttons.
• Press the "A" button until the display indicates "P:01".
• Press the "C" button to turn intensive drying on or of. "P:00" = dishwasher does not turn of automatically,
"P:01" = dishwasher turns of after 1 minute, "P:02" = dishwasher turns of after 120 minutes (2 hours)
• Press [ ] to save the setting.
START
• Close the door (for hidden controls only).
] button.
ON/OFF
] button.
ON/OFF
] button.
ON/OFF
] button.
ON/OFF
] button.
ON/OFF
] until the display indicates "H:00".
START
] until the display shows "H:00".
START
] until the display shows "H:00".
START
] until the display shows "H:00".
START
] to save setting.
START
16