Troubleshooting - Craftsman 917.378411 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
CHART
PROBLEM
CAUSE
Does not start
1. Dirty air filter,
Loss of power
Poor cut -
!uneven
CORRECTION
1. Clean/replace
air filter.
2. Fill fuel tank.
3. Drain tank and refill with
fresh crean fuel.
4. Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
5. Connect wire to plug.
6. Replace spark plug.
7. Tighten blade bolt or
replace blade adapter.
8. Depress control bar to
handle.
g. Replace control bar.
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Loose blade or broken
brade adapter.
8. Control bar in released
position.
9. Control bar defective.
1. Rear of lawn mower
housing or cutting blade
dragging in heavy grass.
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup ef grass, leaves,
and trasll under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights
uneven.
3. Buildup of grass, leaves
and trash under mower.
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
1. Engine flywheel brake is on
when control bar is released.
2. Bent engine crankshaft.
3. Blade adapter broken.
4. Blade dragging in grass.
1. Drive wheels not turning
with drive control engaged.
2. Belt not driving.
1. Set to "Higher Cut"
position.
2. Set to "Higher Cut"
position.
3. Clean/replace
air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
Excessive
1. Replace blade. Tighten
vibration
blade bolt.
2. Contact a Sears or other
qualified service center,
Starter rope hard
topull
Loss of drive
1. Depress control bar to
upper handle before
pulling starter rope.
2. Contact a Sears or other
qualified service center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
1. Adjust or replace drive
control cable.
2. Put belt on pulleys or
replace belts if broken,
17
Tabla de contenido
loading

Tabla de contenido