Pressure Surges; Blockages In The Pump; Drainage; Risk Of Frost - BADU JET Wave Instrucciones Para El Manejo

Safety
2.9.5

Pressure surges

Valves which close suddenly can cause pressure surges which far
exceed the maximum permissible housing pressure of the pump.
 Avoid valves which close suddenly or, if present, close them
slowly.
2.9.6

Blockages in the pump

Pieces of dirt in the suction line can clog and block the pump.
 Remove foreign matter (branches, leaves, clothes, ...) from
the suction opening.
 Check how easily the pump rotates before starting it up and
after longer idle or storage periods.
2.9.7

Drainage

An insufficient drain gap can damage the motor.
 Do not block or seal the drain gap between the pump
housing and the motor.
2.9.8

Risk of frost

 Drain the pump/unit and pipes at risk of freezing in plenty of
time.
 Remove the pump/unit during periods of frost and store it in a
dry room.
2.9.9

Water temperature

The water temperature must not exceed 35 °C.

2.9.10 Safe use of the product

Safe use of the product is no longer guaranteed in the following
instances:
 If the pipework is not in proper condition.
 If the pump seizes. See point 2.8 on page 12.
If protective devices are damaged or missing, e.g. protection

against accidental contact.
 If there is stress on the pump/unit or pipes during installation.
14 EN 01|2018