D-Link DSL-6540U Guía De Instalación Rápida página 4

TROUBLESHOOTING
SET-UP AND CONFIGURATION PROBLEMS
1. How do I configure my DSL-6540U router without the CD ?
- Connect your PC to the router using an Ethernet cable.
- Open a web browser and enter the address http://192.168.0.1
- The default username is 'admin'. The default password is (leave the feld blank).
- If you have changed the password and can not remember it, you will need to reset the router to
set the password back to '' (leave the field blank).
2. How do I reset my router to factory default settings?
- Ensure the router is powered on.
- Press and hold the reset button on the rear of the device for 5-8 seconds.
Note: Resetting the router to factory default will erase the current configuration settings. To re-
configure your settings, log into the router as outlined in question 1, then run the Setup Wizard.
3. What can I do if my router is not working correctly?
- The manual contains a full troubleshooting section and can be downloaded from the D-Link
website (see below), however there are a few quick steps you can take to try and resolve any
issues:
- Check the LED's on the front of the router.The Power LED should be on, and the DSL and LAN
LED should be on as well.
- Check that all the cables are firmly connected at both ends.
- Power the router off for 20 seconds, and then power it back on.
4. Why can I not get an Internet Connection?
- For ADSL ISP users, please contact your ISP to make sure the service has been enabled/
connected by your ISP and that your ISP username and password are correct.
4
DSL-6540U