Tabla de contenido
1.
Confirm Radio Reception
Install the Batteries
NOTE: Perform these steps if battery power will be used.
Remove the screws and door from the battery compartment on the radio panel.
Insert four "C" batteries as shown.
Reinstall the door.
Test the Radio Reception
NOTE: Consult the User Guide if specific operating information is needed.
Connect the FM antenna to the black wire receptacle on the top of the radio panel.
Connect the optional AC power pack if the batteries were not installed.
Turn on the power.
Adjust the radio until an FM station is received. Confirm the radio is operating
correctly.
Confirm there is adequate reception at the installation location if the radio will be
used.
Disconnect the antennas and (if attached) the AC power pack.
Kohler Co.
3
1163755-2-A
Tabla de contenido
