Aigostar 300008HGZ Manual De Instrucciones página 15

GB
8. Wipe clean the lid and the cooker body with a rag,
and it is prohibited to soak the cooker body in water or
spray water to it.
9. After cleaning and maintenance is completed, please
check again the removable coverplate, exhaust valve,
float valve and other components for correct installation.
Electrical Schematic Diagram
220-240 VAC/50Hz
Thermal fuse
L
N
E
Power cord connector
Pressure
switch
Heating
element
Thermostat
25
L
N
Power PCB
Reed switch
Control PCB
(Lid detect switch)
Main sensor
Troubleshooting
The cases in the following tables do not always
indicate a faulty cooker. Please examine the cooker
carefully before contacting the support for repair.
S/N Problem Possible Reason
Float valve stuck
Difficult to close
1
the lid Sealing ring not installed
properly
Float valve in the popped-up
posi�on
Difficult to open
2
the lid
Pressure exists inside the
cooker
No sealing ring or
sealing ring installed
improperly
Steam leaks from
3
the lid Food debris a�ached to the
sealing ring
Sealing ring damaged
Food debris on the float
Steam leaks from
valve gasket
4 float valve
Float valve gasket worn-out
Too li�le food and water in
inner pot
Float valve unable
5
to rise Steam leaks from the lid or
exhaust valve
Exhaust valve not in sealing
Steam comes out
posi�on
6 from exhaust
valve non-stop
Pressure control fails
GB
Solu�on
Close the cover a�er pulling
downwards the float
Posi�on the sealing ring well
Press the float valve lightly
with a chops�ck
Open the lid a�er the
pressure is completely
released.
Install the sealing ring as
required
Clean the sealing ring
Replace the sealing ring
Clean the float valve gasket
Replace the float valve
gasket
Add water and food
according to the recipe
Send to the service center
for repair
Press release bu�on, the
pressure release valve li�
down to the sealing posi�on
Send to the service center
for repair
26