Led Indication; Certification And Compliance; Contact Information - UTC Fire & Security Interlogix DD669-U Hoja De Instalación

• Ensure the Day/Night and Walk Test inputs are
floating/open, so the DD669-U unit is in the Day mode and
the Walk Test mode is off.
The detector will switch the microwave section off for 3 minutes
after a dual alarm. The detector is in PIR only during this timer.

LED indication

Start up
Low voltage
PIR intruder
alarm
Microwave
intruder alarm
(Dual) motion
intruder alarm
Latched PIR
(Memory)
Continuously on Normal blinking (1 Hz)
[1] Tri-color LED.
Specifications
Detector
Range diameter (selectable)
Viewing angle (selectable)
Optical
Microwave frequency
Max microwave output at 1 m 0.003 μW/cm²
Memory
Input power
Peak-to-peak ripple
Detector start-up time
Normal current
Alarm current
Maximum current
Mounting height
Target speed range
Alarm (NC) / Tamper relay
characteristic
Pry-off tamper (not evaluated
by UL/cUL)
Alarm time
Operating temperature
Dimensions ( x H)
Relative humidity
Weight
IP/IK rating
4 / 12
Closed Automatically after 45 s
Open Apply correct voltage
(Alarm)
Automatically after 3 s
Automatically after 3 s
Open Automatically after 3 s
(Alarm)
Switch to Night mode
Dual
20 ±0.5 m (65 ft. 7 in. ± 1 ft. 7 in.)
or 12 ±0.5 m (39 ft. 4 in. ± 1 ft. 7 in.)
360 degrees or 180 degrees
2 x 9 curtains
5.8 GHz
Yes
9 to 15 V (12 V nominal)
For UL/cUL installations: 10 to 15 V
(12 V nominal)
2 V (at 12 V )
45 s
12 mA
For UL/cUL installations: 0.144 W
10 mA
15 mA
2.5 to 5.0 m (8 ft. 2 in. to 16 ft. 5 in.)
0.3 to 3.0 m/s (1 ft./s to 9 ft. 10 in./s)
80 mA, 30 V , Form C, resistive
Optional
3 s
0 to 49°C (32 to 120°F)
138 x 92 mm (5.43 in. x 3.62 in.)
max. 95% (UL/cUL installations)
255 g (9 oz.)
IP30 IK02

Certification and compliance

Manufacturer UTC Fire & Security Americas Corporation, Inc.
1275 Red Fox Rd., Arden Hills, MN 55112-6943, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Certification
FCC Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment
and receiver
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV
technician for help
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
FCC ID: YFYDD669-U
IC This Class B digital apparatus complies with Canadian
ICES-003.
UL/cUL All wiring is to be installed according to National
Electrical Code, NFPA70 and CSA C72.1, Canadian
Electrical Code Part 1, Safety Standard for Electrical
Installations
The product must be connected to a Listed Burglar
System compatible control unit or power supply, that
provides a minimum of 4 hours standby power and has
a voltage output between 10 and 15 VDC.
Perform walk test at least one per year.
Use only a listed power-limited supply.
2002/96/EC (WEEE directive): Products marked with
this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For more
information see: www.recyclethis.info.

Contact information

www.utcfireandsecurity.com or www.interlogix.com
For customer support, see www.interlogix.com/customer-
support.
P/N 146446999-1 • REV A • ISS 25JAN12