Preparing Electrical Connections - Aprimatic AT 80/E Instrucciones Para La Instalacíon Mecánica, El Uso Y El Mantenimiento

3.

PREPARING ELECTRICAL CONNECTIONS

!
Warning
The system must only be installed by skilled personnel qualifi ed in compliance with the regulations of the country of
installation (CEI 64 - 8 / EN 60335-1... standards)
The metallic components of the structure (i.e. the gate and pillars) must have an earth connection.
• Prepare the electrical connection of the controller and safety devices in accordance with the lay-out in
the warnings provided in this manual and comply with the instructions attached to the installed components. Prepare the
cableways (external or buried) up to where the devices will be installed.
• The cableway joints to the box should be sealed to prevent the entry of dampness, insects or small animals.
• POWER SUPPLY: 230
accordance with the length of the line.
If it is necessary to use automation power supply cable sheathing, apply this sheathing before connecting the cable itself
to the derivation boxes.
IMPORTANT! Always install, upstream of the line, a mains switch which guarantees a multipole cut-off with minimum
contact opening of 3 mm (connect it to a 6 A differential overload switch with sensitivity of 30 mA).
• The command and control accessory devices and the emergency button should be placed within sight of the automation,
away from moving parts and at a minimum height of 1.5 m from the ground.
4
d
a
1 control unit .............................................. a 2 x 1,5 mm
antenna 433.92 MHz .............................. c supplied cable
2
3 flashing light ........................................... d 2 x 1 mm
photocell pair .......................................... e transmitter 2 x 0,75 mm
4
5 key switch............................................... f 3 x 0,75 mm
6 OPTIONAL control devices .................... f 3 x 0,75 mm
Proximity reader* , Magnetic card reader* , Electronic keypad*
7 remote control
AT 80/E
2
V AC - Cable 3x1,5mm
1
8 8 8 8
230 VAC
6A
lc= 30mA
(minimum section); the cable cross-section should be calculated in
2
4
3
b
c 5
ti
d
7
2
+ earth
2
2 ; receiver 4 x 0,75 mm
2
2
* optional accessory (see the sales catalogue)
- 17 -
SLIDING GATES
fi g.6. Please heed
6
e
e
NEVER remove, neither
tamper the protective
sponge inside the
operator.
2
Fig.6