AEG DD8694-M Manual Del Usuario página 11

EN
This filter cannot be washed or regenerated. It must be replaced when the C appears on the display
or at least once every 4 months. The filter saturation alarm has to be activated already before.
Activation of the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or
at a later date.
• Press and hold button E (Delay) for 5 seconds, until confirmation appears on the display:
• C flashes twice – Activated Charcoal Filter saturation alarm ACTIVATED.
• C flashes once – Activated Charcoal Filter saturation alarm DEACTIVATED.
REPLACING THE CHARCOAL fILTER
Reset of the alarm signal
• Switch off the hood and the lighting.
• Press the D-key until the display is unlit.
Replacing of the filter
• Open the comfort panels pulling them downwards.
• Remove the metal grease filters.
• Remove the saturated charcoal filter by releasing the
fixing hooks
• Fit the new filter and fasten it in its correct position.
• Put the metal grease filters in their seats.
• Close the comfort panels.
LIGHT REPLACEMENT
20 W halogen light.
• Remove the 2 screws fixing the Lighting support, and
pull it out of from the Hood.
• Extract the lamp from the Support
.• Replace with another of the same type, making sure
that the two pins are properly inserted in the lamp
holder socket holes.
• Refit the Support, fixing it in place with the two
screws removed as above.
Charcoal filter (recycling version)
Lighting
11