Troubleshooting - POLTI Forzaspira CS200 Manual De Instrucciones

Ocultar thumbs Ver también para Forzaspira CS200:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
CARE OF YOUR APPLIANCE
• Before attempting any maintenance opera-
tion, always disconnect the appliance from
the mains.
• To clean the body of the appliance, simply use a
moist cloth. Do not use solvents or detergents
which may harm the body material.
DUST COLLECTION BAG
BAG REPLACEMENT
♦ When the dust-collection bag (F) is full, the indi-
cator (5) will turn red (Fig. 12).
Note: The indicator (5) does not work with the
suction control (6) set on minimum.
The fill level of the bag must be checked with the
suction control (6) at maximum suction power.
♦ Turn the appliance off and disconnect it.
♦ Press the button (12) and lift the lid (4) (Fig. 13 -
14).
♦ Pull out the full dust-collection bag (Fig. 15) and
throw it away.
♦ Insert a new dust-collection bag, reversing the
process (Fig. 16).
♦ Close the lid again.
Note: If the dust-collection bag is not inserted,
the lid will not close.
Note:
The dust-collection bags can be purchased at all
major household-appliance shops or online at
www.polti.com.
PROBLEM
The vacuum cleaner does not
turn on
The vacuum has little or no
suction
FORZASPIRA CS200
♦ Turn the appliance off and disconnect it.
♦ Press the button (12) and lift the lid (4).
♦ Pull out the dust-collection bag.
♦ Pull the motor filter out as shown in the figure (17
♦ After having washed it with water, dry thoroughly.
♦ Replace everything repeating the steps above in
REMOVING AND CLEANING THE HEPA FILTER
♦ Lift the filter grill (8) and remove the filter (Fig.
♦ Rinse the filter under cold running water.
♦ After washing, shake it gently to remove any resi-
ATTENTION
♦ Do not dry the filter using heat. Wait 24 hours
♦ Replace torn filters.
♦ The filters should be cleaned every 4 months.
♦ Do not clean the filters with tools which could
♦ Do not use detergents, do not rub the filter,

TROUBLESHOOTING

CAUSE
Power supply cable (11) not in-
serted
ON/OFF switch (7) is turned off
Flexible hose / telescopic tube
clogged.
Dust-collection bag (7) over full.
Check that suction control is not
at the minimum level.
There is no dust-collection bag.
The container lid is not comple-
tely closed.
17
MOTOR AIR-FILTER CLEANING
- 18).
If the filter is torn, replace it.
reverse.
12).
dual dirt and excess water.
before replacing the filters in the appliance.
damage them.
and do not wash it in a dishwasher.
SOLUTION
Connect the power supply cable (11)
to a suitable electric socket.
Turn on the ON/OFF switch (7).
Clean the tubes.
Replace the dust-collection bag (7).
Increase the suction level.
Insert the dust-collection bag.
Close the lid properly.
Tabla de contenido
loading

Tabla de contenido