Tabla de contenido
Idiomas disponibles
Idiomas disponibles
frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled
down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as
these will damage the surface.
Cleaning the soleplate; Do not use scouring pads or harsh cleaners on the soleplate as these will dam-
age the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the sole-
plate, simply wipe with soft damp cloth and wipe dry.
SELF-CLEANING
Fill the half of the water reservoir.
Set the temperature control to its maximum position.
Insert the main plug into the wall socket.
Allow the iron to heat up until the indicator light turns off.
Unplug the steam iron.
Holding the iron horizontally over the sink and press the button of Self clean, in case if not have this
button change the steam control to the maximum position.
Boiling water and steam will be ejected from the holes in soleplate with impurities washed out Move
the iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during storage.
Is recommended to do the self-cleaning at least every two weeks.
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate.
The resin filter is permanent and does not need replacing.
PLEASE NOTE: Do not use chemical additives, scented substances or decalcifies. Failure to comply
with the above-mentioned regulations leads to the loss of guarantee.
AUTO SHUT-OFF
This steam iron is fitted with an automatic switch-off system. This stops the iron from heating up, if
the iron is resting on its sole of the iron and is not moved for about 30 seconds, there will be a warning
beep and the control lamp for the automatic switch-off temperature / automatic switch-off control
lamp flashes. The iron will stop heating up, to deactivate the automatic switch off, lift up the iron and
move it gently from side to side. the econtrol lamp for the automatic switch-off temperature/automat-
ic switch-off control lamp goes out and the iron will heat up again.
If the iron is resting on its base and is not moved for about 8 seconds, there will be a warning beep and
the control lamp for the automatic switch-off lamp flashes. The iron will stop heating up. To deactivate
the automatic switch-off, lift up the iron and move it gently from side to side. The control lamp for the
automatic switch-off goes out and the iron will heat up again.
19
Tabla de contenido
