Klarstein 10031386 Manual De Instrucciones página 26

Press this button, you can select the running mode as follows: AUTO > COOL > DRY >
10 MODE
HEAT > FAN. Note: HEAT mode is not available for cool only units.
Press this button to enter SLEEP mode, which the unit will exit after 10 hours of conti-
11 SLEEP nuous operation and restore to the previous status. Note:The SLEEP function cannot be
activated in FAN mode.
12 SWING Press this button to activate up/down swing and press it again to fix the swing position.
13 SWING Press this button to activate left/right swing and press it again to fix the swing position.
• The Anti-F functions when the unit is turned off with the remote controller in COOL,
• This function is not set in the factory. You may set it or cancel it any time you want
14
Anti-F
• To cancel Anti-F: Power off the unit. With both the unit and the remote controller
• Note: With Anti-F activated, it is advised not to turn ON the unit again before it is fully
ELE.H If this button is pressed in HEAT mode, the electric heating will be turned on/off.
If this button is pressed in COOL mode, the unit will enter the ECO mode which has
the lowest electricity consumption, and exit it automatically 8 hours after. Changing
15
modes or turning off the remote controller will automatically cancel the ECO function.
ECO
Press ECO button in ECO mode to exit this mode. Note: The ECO mode only works for
inverter units.
Automatic operation mode
• Press the "MODE" button, select the automatic operation mode.
• By pressing the "SPEED" button, you can select the fan speed from LOW, MID, HIGH, AUTO.
• Press the "ON/OFF" button, the air-conditioner starts to operate.
• Press the "ON/OFF" button again, the air-conditioner stops.
• Note: In the fan operation mode, the temperature settings is non-effective.
DRY or AUTO mode. It will operate in HEAT mode (FAN mode for cool only units),
with the internal fan running with weak flow for 3 minute before stop, to remove the
moisture within the evaporator so as to prevent it from giving off bad smell from
mold.
as follows: With both the unit and the remote controller OFF, point the remote con-
troller at the unit and press "Anti-F" button once, the buzzer will sound 5 times after
5 times, indicating this function is set. Once set, this function will remain valid except
when the unit is power off or until it is canceled.
OFF, point the remote controller at the unit and press this button once, the buzzer
will sound 3 times after 5 times, indicating this function is canceled.
OFF. Anti-F function will be invalid when OFF timer is set.
26