ECCOTEMP EL22 Serie Manual De Instrucciones página 2

Phone: 866-356-1992 | Email: [email protected] | Address: 315 - A Industrial RD Summerville, SC 29483
Eccotemp Systems, LLC
315-A Industrial Road
Summerville, SC 29483
866-356-1992
AUTOMATIC INSTANTANEOUS WATER HEATER
MODEL #: EL22-NG Maximum Input Ra�ng (Btu per hour):
SERIAL #: Minimum Input Ra�ng (Btu per hour):
NATURAL GAS
TYPE GAS: ONLY
120 Volts
Voltage:
60 Hz
Frequency:
Amps: Less than 12 Amperes
As used in this standard, the quan�ty of water obtained by mul�plying the
Recovery
manufacturer's input ra�ng in Btu per hour by the thermal efficiency and dividing
the product by 825 Btu per gallon. This is based on a 100°F temperature rise, and
Ra�ng:
a nominal specific heat for water of 8.25 Btu per gallon per degree F.
Not recommended in excess of 2,000 �. above sea level.
CANADIAN HIGH ALTITUDE RATING
Input (btu/hr)
Manifold pressure (in. w.c)
ANSI Z21.10.3-2014/CSA 4.3-2014
SUITABLE FOR WATER (POTABLE) HEATING ONLY
CAN 2.17 STANDARD
This appliance must be installed in accordance
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the
Z223.1/NFPA 54 or the CSA B149.1, Natural
vicinity of this or any other appliance
The unit must be installed on a fire retardant area, and must be away from all combus�ble
materials. Clearance should be 1.75 � to the le� and right side of combus�ble materials, and
6.75 � to the front.
Open on three sides and an overhead clearance of 36"
The temperature and pressure relief valve provided by the manufacturer shall be installed at the �me of
installa�on of the heater in the loca�on specified by the manufacturer. Local codes shall govern
installa�on of relief devices. For safe opera�on of the water heater, the relief valve must not be removed
or plugged.
OUTDOOR USE ONLY
Eccotemp Systems, LLC
315-A Industrial Road
Summerville, SC 29483
866-356-1992
AUTOMATIC INSTANTANEOUS WATER HEATER
EL22-ING
MODEL #: Maximum Input Ra�ng (Btu per hour):
SERIAL #: Minimum Input Ra�ng (Btu per hour):
NATURAL GAS
TYPE GAS: ONLY
120 Volts
Voltage:
Frequency: 60 Hz
Less than 12 Amperes
Amps:
As used in this standard, the quan�ty of water obtained by mul�plying the
Recovery
manufacturer's input ra�ng in Btu per hour by the thermal efficiency and dividing
Ra�ng: the product by 825 Btu per gallon. This is based on a 100°F temperature rise, and
a nominal specific heat for water of 8.25 Btu per gallon per degree F.
Not recommended in excess of 2,000 �. above sea level.
CANADIAN HIGH ALTITUDE RATING
Input (btu/hr)
Manifold pressure (in. w.c)
ANSI Z21.10.3-2014/CSA 4.3-2014
SUITABLE FOR WATER (POTABLE) HEATING ONLY
CAN 2.17 STANDARD
This appliance must be installed in accordance with
FOR YOUR SAFETY
local codes or, in the absence of local codes, the
Do not store or use gasoline or other
National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the
flammable vapors and liquids in the
CSA B149.1, Natural Gas and Propane Installation Code
vicinity of this or any other appliance
The unit must be installed on a fire retardant area, and must be away from all combus�ble materials.
Minimum clearances from combus�ble construc�on, 6 inches sides, 0 inches back and 12 inches top.
The temperature and pressure relief valve provided by the manufacturer shall be installed at the �me of
installa�on of the heater in the loca�on specified by the manufacturer. Local codes shall govern
installa�on of relief devices. For safe opera�on of the water heater, the relief valve must not be removed
or plugged.
This water heater requires a special ven�ng system. Refer to the installa�on instruc�ons for parts list and
method of installa�on.
Support: Eccotemp.com/help-desk
140,000
25,000
4" w.c
Minimum Inlet Gas Pressure:
(1Kpa)
10.5'' w.c
Maximum Inlet Gas Pressure:
(2.61Kpa)
3.05'' w.c
Manifold Pressure:
(0.76Kpa)
Maximum Working Pressure: 150 psi
Category III Water Heater
0-2000 feet 2000-4500 feet
140,000 126,000
3.05 2.24
with local codes or, in the absence of local
codes, the National Fuel Gas Code, ANSI
Gas and Propane Installation Code
140,000
25,000
4" w.c
Minimum Inlet Gas Pressure:
(1Kpa)
10.5'' w.c
Maximum Inlet Gas Pressure:
(2.61Kpa)
3.05'' w.c
Manifold Pressure:
(0.76Kpa)
150 psi
Maximum Working Pressure:
Category III Water Heater
0-2000 feet 2000-4500 feet
140,000 126,000
2.24
3.05
Shop Online: Eccotemp.com/products
Eccotemp Systems, LLC
315-A Industrial Road
Summerville, SC 29483
866-356-1992
AUTOMATIC INSTANTANEOUS WATER HEATER
EL22-LP
MODEL #: Maximum Input Ra�ng (Btu per hour):
SERIAL #: Minimum Input Ra�ng (Btu per hour):
TYPE GAS: LIQUID PROPANE ONLY Minimum Inlet Gas Pressure:
120 Volts
Voltage: Maximum Inlet Gas Pressure:
60 Hz
Frequency:
Less than 12 Amperes
Amps: Maximum Working Pressure:
As used in this standard, the quan�ty of water obtained by mul�plying the
Recovery
manufacturer's input ra�ng in Btu per hour by the thermal efficiency and dividing
Ra�ng: the product by 825 Btu per gallon. This is based on a 100°F temperature rise, and
a nominal specific heat for water of 8.25 Btu per gallon per degree F.
Not recommended in excess of 2,000 �. above sea level.
CANADIAN HIGH ALTITUDE RATING
0-2000 feet
Input (btu/hr)
Manifold pressure (in. w.c)
ANSI Z21.10.3-2014/CSA 4.3-2014
SUITABLE FOR WATER (POTABLE) HEATING ONLY
CAN 2.17 STANDARD
This appliance must be installed in accordance
FOR YOUR SAFETY
with local codes or, in the absence of local
Do not store or use gasoline or other
codes, the National Fuel Gas Code, ANSI
flammable vapors and liquids in the
Z223.1/NFPA 54 or the CSA B149.1, Natural
vicinity of this or any other appliance
Gas and Propane Installation Code
The unit must be installed on a fire retardant area, and must be away from all combus�ble
materials. Clearance should be 1.75 � to the le� and right side of combus�ble materials, and
6.75 � to the front.
Open on three sides and an overhead clearance of 36"
The temperature and pressure relief valve provided by the manufacturer shall be installed at the �me of
installa�on of the heater in the loca�on specified by the manufacturer. Local codes shall govern
installa�on of relief devices. For safe opera�on of the water heater, the relief valve must not be removed
or plugged.
OUTDOOR USE ONLY
Eccotemp Systems, LLC
315-A Industrial Road
Summerville, SC 29483
866-356-1992
AUTOMATIC INSTANTANEOUS WATER HEATER
EL22-ILP
MODEL #: Maximum Input Ra�ng (Btu per hour):
SERIAL #: Minimum Input Ra�ng (Btu per hour):
LIQUID PROPANE
TYPE GAS: ONLY Minimum Inlet Gas Pressure:
120 Volts
Voltage: Maximum Inlet Gas Pressure:
60 Hz
Frequency:
Less than 12 Amperes
Amps: Maximum Working Pressure:
As used in this standard, the quan�ty of water obtained by mul�plying the
Recovery
manufacturer's input ra�ng in Btu per hour by the thermal efficiency and dividing
Ra�ng: the product by 825 Btu per gallon. This is based on a 100°F temperature rise, and
a nominal specific heat for water of 8.25 Btu per gallon per degree F.
Not recommended in excess of 2,000 �. above sea level.
CANADIAN HIGH ALTITUDE RATING
0-2000 feet
Input (btu/hr)
Manifold pressure (in. w.c)
ANSI Z21.10.3-2014/CSA 4.3-2014
SUITABLE FOR WATER (POTABLE) HEATING ONLY
CAN 2.17 STANDARD
This appliance must be installed in accordance with
FOR YOUR SAFETY
local codes or, in the absence of local codes, the
Do not store or use gasoline or other
National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the
flammable vapors and liquids in the
CSA B149.1, Natural Gas and Propane Installation Code
vicinity of this or any other appliance
The unit must be installed on a fire retardant area, and must be away from all combus�ble materials.
Minimum clearances from combus�ble construc�on, 6 inches sides, 0 inches back and 12 inches top.
The temperature and pressure relief valve provided by the manufacturer shall be installed at the �me of
installa�on of the heater in the loca�on specified by the manufacturer. Local codes shall govern
installa�on of relief devices. For safe opera�on of the water heater, the relief valve must not be removed
or plugged.
This water heater requires a special ven�ng system. Refer to the installa�on instruc�ons for parts list and
method of installa�on.
140,000
25,000
9'' w.c
(2.24 Kpa)
13'' w.c
(3.23Kpa)
4.93'' w.c
Manifold Pressure:
(1.22Kpa)
150 psi
Category III Water Heater
2000-4500 feet
140,000 126,000
3.62
4.93
140,000
25,000
9'' w.c
(2.24 Kpa)
13'' w.c
(3.23Kpa)
4.93'' w.c
Manifold Pressure:
(1.22Kpa)
150 psi
Category III Water Heater
2000-4500 feet
140,000 126,000
3.62
4.93
Store Locator: Eccotemp.com/locator