Connecting Power And Signal Cables; Connecting The Signal Between Joined Panels - Chauvet DJ Vivid 4X4 Manual De Instrucciones

Connecting Power and Signal Cables

The following sections provide information and diagrams on connecting signal and power between panels.
Refer to the Introduction

Connecting the Signal Between Joined Panels

Signal cable panel connections can use several different configurations. The basic configuration to
connect the signal from one panel to the next is as follows:
1. The source signal is connected to the first panel.
2. A signal cable is then connected from the first panel.
3. The connections continue to daisy-chain until all panels are connected.
4. The route of the cables used to make the signal connections can vary.
The following diagram is a recommended suggestion for simple signal connections between panels.
Video Signal
Vivid Drive 23N
17
or Operation sections in this User Manual for available cables and item numbers.
Signal Jumper Cable
Etherkon connection to the
first Vivid 4 in the series
Video Signal Cable in from
Vivid Drive 23N maximum
cable length 100 m/328 ft
Connecting and Cabling
May be used to run a backup
line to the Vivid Drive 23N
Vivid 4 X4 User Manual Rev. 3