Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing
the blower
to the plenum
Install four nylon insert nuts to the studs on the blower,
finger
tighten
until resistance
is felt. Position the blower
discharge
opening
to match the ductwork.
Slide the nuts
on the side of the blower
housing into the four keyhole
openings
on the side of the plenum
and allow
to slide
down into the slots.
Using a wrench
or ratchet
from the
inside of the plenum
tighten
the nuts.
Figure
17B - 36" MODEL
ATTACH PLENUM TO THE COOKTOP
Installing
the transition
to the blower
Attach
the transition
to the outlet
of the blower
using
four screws.
Tape the joint to seal.
Figure
19 - ATTACH BLOWER TO THE PLENUM
One screw per side
Wide Head Phillips Screws
Figure 18 - ATTACH TRANSMON
TO THE BLOWER
9
Figure 20 - NUT LOCATIONS iNSiDE THE PLENUM
Tabla de contenido
