Samsung WA54R7200A Serie Manual Del Usuario página 25

STEP 5 Power on
Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet
protected by a 15-amp fuse or circuit breaker. Then, press Power to turn on the washer.
STEP 6 Run a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 lb. of laundry into the tub.
2. Press Power to turn on your washer.
3. Turn the Cycle Selector to RINSE+SPIN.
4. Press and hold Start/Pause (Hold to Start) to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when
washing and spinning, and should drain well during the spin cycle.
NOTE
• If water leaks while water is being supplied or drained, check the water connections.
See "STEP 2 Connect the water hose" on page 19.
• If the washer rocks and vibrates excessively, level your washer again. See "STEP 4
Level the washer" on page 22.
Untitled-3 25
English 25
2019-04-26 PM 12:09:40