Tabla de contenido
Idiomas disponibles
Idiomas disponibles
...............................................................
ASSE .... LY
.......................
LowEn H ANI LE
..........
Figure 1 shows the snow thrower in the shipping position,
Figure 2 shows the snow thrower completely
assembled,
Reference
to the right and left hand side of the snow thrower
is from the operator's
position
at the handle,
TO REMOVE SNOW THROWER
FROM CARTON
(See Fig. 1)
e
Remove the staples from top of carton to avoid injury
e
Remove top pallet from carton.
•
Locate and remove container of 5W30 oil in parts box,
e
Cut and discard plastic ties securing the crank assem.
bly to the pallet and place the assembly aside. Discard
pallet,
e
Cut all fourcorners
of the carton from top to bottom and
lay the panels flat,
•
Cut the bands holding the snow thrower to the tower
pallet..
e
Remove packing from console
•
Remove paper ties from upper handles,
e
With two 9/!6
inch wrenches,
_oosen (but do not
remove)
both
bolts securing
the upper and lower
handles by holding the inner
nut on the inside of the
handle wh}le turning
the outside
bolt counter-clock-
wise as shown in Fig 4A, page 8
e
Swing the upper handle into the operating
position as
shown in Fig, 2,
e
Hold the inner nut and tighten the outside bolt up
against the handle as shown in Fig 4A, page 8
PANEL
CLUTCH
CABLE
AUGER
D,iV .........
UPPER
HANDLE
ASSEMBLY
FIG. 1
DRIVE
LEVER
CLUTCH
HEADLIGHT
SHIFTER
LEVER
CHUTE
e
Position control panel bracket so that the slot is in tine
with mounting
hole in the panet.
e
While holding the outside bo_t, tighten the innermost
nut up against the control panel bracket as shown in
Fig. 4A, page 8,
NOTE: If the cables have become disconnected from the
clutch levers, reinstall the cables as shown in Fig 3 and Fig
3A,,
o
O
Tighten handle bolts securely
Rol! the snow thrower off the skid by pulling on the
handle, CAUTION; DO NOT back over cables
e
Properly dispose
of discarded packing.
NOTE: This snow thrower is equipped with a track drive and
can be hard to push
when
the engine
is not running,
However,
this unit has kfick pins in the track wheels which,
in the proper setting, allow the unit to be transported
easily
without the engine being started, For instructions
on the use
of these klick pins. see the Track Drive/Free-Wheel
Feature
on page I2,
4" LG, FREE 3" LG, FREE
TRACTION
_STATE
DRIVE"-... /
SPR,.G
TRAOT,O.
DRWE II ///,_71_,
SPRING ---_
LEVEF_ _
.
FIG. 3A
FIG. 2
, N
DRIVE
LEVER
FIG, 3
CAUTION:
IF YOU
ARE
REMOVING
A
SNOW
FROM
ANY GRAVELED
OR UN-
EVEN SURFACE,
RAISE THE FRONT
OF
THE SNOWTHROWER
BY MOVING
THE
SKIDS
DOWN.
THIS
WiLL
HELP
TO
PREVENT
STONES
AND
OTHER
DEBRIS
FROM
BEING
PICKED
UP AND THROWN
BY THE AUGER.
Tabla de contenido
