Thunderbay Y43 Manual De Funcionamiento página 10

STEPS FOR CLEANING BLOCK STYLE FOAM AIR FILTER
NOTE: SEE PARTS EXPLOSION ON PAGE 16
1.
Before removing the air filter cover, move the choke lever to the choke position. (Figure 1)
2. To remove air filter cover, get away the bolt on the cover and squeeze the latch tabs on both sides of the cover.
(Figure 2)
3. Once the latch tabs are released, remove the air filter cover by rotating the cover away from the engine. (Figure 3)
4. Remove the white plastic cover and the foam filter element (Figure 4、5) and replace with anew oiled filter, or clean
the original foam filter with warm water and mild soap by following the previous steps for Cleaning Air Filter.
Remember to thoroughly oil the foam filter with 30 or 40 weight motor oil and squeeze out any excess oil.
5. Reinstall the foam filter and white plastic cover, pressing it in place to ensure that the foam is fully seated into its
sealed position. (Figure 6)
6. Replace the air filter cover so that it fully snaps into place and is secured by the latch tabs. Check that the cover is
securely attached by pulling slightly on the cover. If the cover doesn't move when pulled, it is secure.
Figure 1
Figure 4
Figure 2
Figure 5
CLEANING FOAM AIR FILTER
Figure 3
Figure 6
Y43 Model
10