About The Filter Cartridge - GE GXWH04F Instrucciones De Instalación

Performance Data Sheet
GXWH20S system using FXUSC (Rev. 2) filter has been tested according to
NSF/ANSI 42 for reduction of the substances listed below. The concentration
of the indicated substances in water entering the system
SUBSTANCE
Particulate, Class V particles 30 to <50
Replacement Filter Cartridges
Several variables determine how long the cartridge will last
in your Household Water Filtration System. These include:
levels of sediment or other undesirable substances in
your water.
the amount of water you use.
the filter location (filtering all or part of your household
water).
Filter Cartridge Replacement
You should change your filter when the water flow is noticeably reduced or at least every 3 months.
1 Turn off water to filter. For model GXWH04F, water
must be shut off from an upstream valve. For model
GXWH20S, rotate control handle to the BYPASS or OFF
position. (See Control Handle.)
2 Press the red pressure-release button to release
pressure.
3 Unscrew the filter canister and discard used filter.
Wash the filter canister with mild soap and water.
Do not use harsh cleaners or hot water.
4 Inspect the filter canister O-ring. Make sure it is lightly
lubricated with clean food-grade silicone grease
(silicone grease is available through GE Parts and
Service: 1.800.626.2002, part number WS60S10005).
Be sure the O-ring is seated in the groove. It is
recommended that you replace the O-ring if it is
damaged.
5 Place a new filter cartridge into the filter housing,
making sure it is centered and completely seated on
the bottom seal.
6 Reinstall the filter canister to the unit. Tighten filter
canister to seal. Use canister wrench if necessary.
Control Handle (GXWH20S Model Only)
OFF
Shuts off water.

ABOUT THE FILTER CARTRIDGE

INFLUENT CHALLENGE
CONCENTRATION
At least 1,000 particles/mL
GE MODEL
FXUSC (Rev.2)
FXWPC
FXWTC (Rev.2)
FXWSC
* Claims not substantiated by NSF. Based on manufacturer's testing only.
7 Slowly rotate control handle to the FILTER position
(model GXWH20S) or slowly turn on the upstream
shut-off valve (model GXWH04F).
8 Press the red pressure-release button to remove
trapped air.
9 For initial system installation, open any downstream
faucet and allow filter system to flush for 30 minutes
(120 gallons) (model GXWH20S) or 15 minutes (60
gallons) (model GXWH04F).
For filter replacement, see chart above for individual
filter flush times.
GXWH04F
Timer
Filter
cartridge
FILTER
For filtered water. Directs water flow
through filter.
was reduced to a concentration less than or equal to the permissible limit
for water leaving the system, as specified in NSF/ANSI 42. While testing was
performed under standard laboratory conditions, actual performance may
vary.
Rated Service Flow: 4 gpm
Minimum–Maximum Supply Water Pressure: 20–125 psi
REDUCTION
(2.1-6.9 bar)
REQUIREMENT
Minimum–Maximum Supply Water Temperature: 40–100°F
> +85%
(4.4–37.7°F)
REDUCES LIFE
Sediment 3 month/16,000
gallons*
Sediment* 3 month/16,000
gallons*
Sediment*, 3 month/700
Chlorine, Taste and gallons
Odor
Sediment* 3 months/ 16,000
gallons*
Red pressure-
release
button
Head
O-ring seal
Housing canister
Permits flow of water to the house without flowing
through the filter. Use this position for filter changes
or if filtered water is not desired.
2
Rated Service Flow: 4 gpm
FLUSH TIME
30 minutes
(120 gallons)
15 minutes
(60 gallons)
5 minutes
(20 gallons)
15 minutes
(60 gallons)
Turn canister wrench
clockwise to remove
GXWH20S
Head
Red pressure-
release button
O-ring seal
Filter
cartridge
BYPASS
CONSTRUCTION
Polypropylene
Fiber
Pleated
Carbon Paper
String Wound
Housing
canister
Timer
Control
handle
Housing
canister