Amplifier Settings - Orion HCCA Serie Manual Del Usuario

SPECIFICATIONS (continued)
Amplifier Section
Protection
Terminal Wire Gauge
Remote 12 - 16 AWG
Speaker 8 - 12 AWG
Input Impedance,
Balanced line
Fuse Size
Balanced Line Inputs
Dimensions (L x W x H)
Crossover Section
High Pass Crossover Continuously variable
Low Pass Crossover Continuously variable
Intelli-Q
* Continuous 4Ω load 20Hz to 20kHz, < 1% THD, with input voltage at 14.4 VDC.
** Continuous 2Ω load 20Hz to 20kHz, < 1% THD, with input voltage at 14.4 VDC.
© 2009 Directed Electronics. All rights reserved.
HCCA10002 HCCA10004
Thermal, DC offset, short protection, under-
voltage, over-voltage
Power 4 AWG Power 4 AWG
Remote 12 - 16 AWG
Ground 4 AWG Ground 4 AWG
Speaker 8 - 12 AWG
20 kΩ 20 kΩ
100 Amp 100 Amp
Yes
19.75"x 10.3"x 2.5" 19.75"x 10.3"x 2.5"
Continuously variable
(50-2kHz) (50-2kHz)
Continuously variable
(50-2kHz) (50-2kHz)
0-10dB 0-10dB

AMPLIFIER SETTINGS

The input section of the amplifier consists of gain controls, high pass
and low pass crossovers controls, Intelli-Q control and RCA inputs and
outputs. The input section makes it easy to adapt this amplifier to
most system configurations.
These Orion amplifiers have level adjustments to allow for easy inte-
gration with any source unit. The input sensitivity is a push button
adjustment, with the depressed (in) position giving you a range from
400mV to 8V while in the out position this range is 200mV to 4V. Refer
Yes
to Testing the System and Adjusting the Sound of the System sections
of this guide for detailed instructions on setting the gain.
Incorporated in the high-pass crossover, Intelli-Q maximizes the
performance of a subwoofer. The high-pass subsonic filter removes
unwanted bass output from the woofer, increasing the output of a
subwoofer by as much as 3 dB due to the increased mechanical power
handling. Depending on the enclosure, using Intelli-Q can increase the
low frequency response by an additional 10dB! The type of enclosure
used and the woofer's excursion capability determine acceptable
boost levels. Listed next are recommended boost levels for different
enclosure designs.
7