Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Follow the troubleshooting guide below in the event that your dishwasher does not operate as
expected. Perform the basic checks below before calling an authorized service agent:
1.
Make sure that the main water supply is turned on.
2.
Make sure that the main power is turned on.
3.
Make sure that the flexible water fill and drain hoses are not kinked.
Condition
Dishwasher will not run.
Low or no water.
Poor wash results.
Dishwasher stays in
wash cycle.
Cause
Door not closed.
Main power OFF.
Dishwasher OFF.
Main water supply off.
PRV setting incorrect
Solenoid strainer clogged.
Solenoid valve defective.
Detergent not added to tank
Wares incorrectly loaded.
in dishrack.
Clogged sump filter.
Clogged spray arms.
Thermostat defective.
Detergent motor defective.
Water temperature low.
Rinse Sentry extends wash
mode to allow final rinse
water booster temperature
to reach 180˚F/82˚C.
Troubleshooting
Troubleshooting
Solution
Close door completely.
Check breaker on panel.
Turn dishwasher ON.
Open supply valve.
Adjust the PRV setting
Clean strainer.
Contact Service Agent.
Add detergent.
Reposition wares or
reduce amount of wares.
Clean sump filter.
Clean spray arms.
Contact Service Agent.
Contact Service Agent
Contact Service Agent
Contact Service Agent
because booster
thermostat is defective.
13
Capítulos
Tabla de contenido
