Troubleshooting - McCulloch MC1350 Guia Del Usuario

PROBLEM
Unit fails to heat up.
Steam output is weak or
intermittent.
Excessive amount of water in
steam.
NOTE: Unit produces wet steam
– it is normal for steam to
contain some amount of water.
Accessories do not stay firmly
connected to Steam nozzle.
No steam but can hear pump.
14 | ENGLISH

Troubleshooting

POSSIBLE CAUSE
Unit is not plugged in.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or otherwise in
need of repair.
Water Reservoir is empty.
Mineral build-up in unit.
Water level in Water Reservoir is
running out.
Mineral build-up in unit.
Water condensation in Steam
Hose.
Accessories not properly installed.
Water Treatment Cartridge is dry.
SOLUTION
Plug power cord into electrical outlet.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 16 for details).
Refer to Filling Water Reservoir
procedure on Page 11.
Refer to Mineral Build-up section
on Page 13 for cleaning procedure.
Refer to Filling Water Reservoir
procedure on Page 11.
Refer to Mineral Build-up section
on Page 13 for cleaning procedure.
Point nozzle towards sink, tub or
ground and shake while pressing
Steam Trigger. Continue until
excess water is released.
Check to make sure that acces-
sories are properly connected, per
procedures on Pages 8-10.
Allow pump to prime water
through it.
Allow Water Treatment Cartridge
to soak in water for one minute
before installing into unit.