Procedure
1. Remove plastic cap from water valve inlet port.
A
A. Water valve inlet port
Cap removal
2. Place brass nut and brass sleeve on copper tubing.
(Brass nut and sleeve are found in your literature
packet.) Insert copper tubing into water valve inlet
port. Connect brass nut on copper tubing to water
valve inlet port. Make sure copper tubing is secure
by pulling on copper tubing.
E
A. "P" clamp
C. Brass sleeve
E. Water valve inlet port
Water connection
3. Turn on water supply to refrigerator and check for
leaks. Correct any leaks at connection. Be careful
not to overtighten connection.
4. Create a service loop using extreme care to avoid
kinks. Secure copper tubing to refrigerator cabinet
with a "P" clamp.
B
B. Plastic cap
A
B
C
D
B. Copper tubing
D. Brass nut
Controls
This refrigerator is designed to operate at normal
household temperatures of 55° to 110°F (13° to 43°C).
Refrigerator and Freezer Controls
Refrigerator control is located on upper rear wall of
refrigerator section. Freezer control is located on left
front ceiling of freezer section.
B
A. Refrigerator control
Controls
When freezer control is set to OFF , neither refrigerator
nor freezer sections will cool. Initially, set both controls to
4 . Wait 24 hours for refrigerator and freezer sections to
reach desired temperatures. After 24 hours, adjust
controls, one number at a time, as desired. 1 is warmest
setting and 7 is coldest.
Setting Controls
Set controls precisely with a household thermometer that
includes temperatures between -5° to 50°F
(-21° to 10°C).
Put thermometer snugly between frozen packages in
freezer section. Wait 5–8 hours. If freezer temperature is
not 0° to 2°F (-17° to -16°C), adjust control, 1 number at
a time. Check again after 5–8 hours.
Put thermometer in a glass of water in middle of
refrigerator section. Wait 5–8 hours. If refrigerator
temperature is not 38° to 40°F (3° to 4°C), adjust control,
1 number at a time. Check again after 5–8 hours.
7
A
B. Freezer control