Indoor Unit Installation; Refrigerant Piping Installation: - Goodman MSC 15 SEER 9,000 BTUH Manual De Instalación Y Funcionamiento

Indoor Unit Installation

Installation of Mounting Bracket
1. Install the mounting bracket horizontally and securely to
the wall, allowing room for access on either side of the
unit.
2 If the wall is constructed of brick, concrete or similar
material, drill eight (8) 3/16" (5 mm) diameter holes in the
wall. Insert the clip anchor for appropriate mounting
screws.
3. Install the mounting bracket on the wall with eight (8)
type "A" screws.
NOTE: Install the mounting bracket and drill the holes in the
wall according to the wall structure and the correspond-
ing mounting points on the mounting bracket. (The
mounting brackets vary according to the model.)
Correct orientation
of Installation Plate
4. Determine the hole positions according to the diagram
detailed in Figures 5A and 5B. Drill one (1) 2.5" hole
( 65mm), slanting slightly to the outside.
NOTE: Always use wall hole conduit when drilling metal
grid, metal plate, etc.
15 SEER
C
Incorrect orientation
of Installation Plate
Figure 4
Indoor unit outline
D
A
Figure 5A
19 SEER
C
Refrigerant Piping & Condensate Piping
Installation:
5. Drain hose should be installed with a slight downward
slope. (See Figure 6.)
Indoor
Do NOT install drain hose as shown in Figure 7.
Do not block water flow by a rise.
6. When connecting extension drain hose, insulate the con-
necting part of the extension drain hose with a shield
pipe. Do not allow the drain hose to be slack.
7. REFRIGERANT PIPING INSTALLATION:: For the left-
hand and right-hand piping, remove the pipe cover from
the side panel. (Figure 8.)
4
D
Figure 5B
Wall
O utdoor
Figure 6
Do not put the end of
drain hose into water.
Figure 7