Operating Procedures; Preparing The Machine For Operation - Clarke Carpet Master 30 Libro De Instrucciones

Ocultar thumbs Ver también para Carpet Master 30:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATING PROCEDURES

DANGER:
Failure to read the Owner's Manual prior to
operating or attempting any service or main-
tenance procedure to your machine could
result in injury to you or to other personnel;
damage to the machine or to other property
could occur as well. You must have training
in the operation of this machine before using
it. If your operator(s) cannot read English,
have this manual explained fully before at-
tempting to operate this machine.
WARNING: Machines can cause an explosion when
near flammable materials and vapors. Do
not use or store this machine with or near
fuels, grain dust, solvents, thinners, or
other flammable materials. Do not use
flammables to clean this machine.
WARNING: To reduce the risk of fire, electric shock, or
injury, do not pick up anything that is
burning or smoking, such as cigarettes,
matches or hot ashes.

PREPARING THE MACHINE FOR OPERATION:

To prepare the machine for operation, make sure it is of correct
voltage and properly assembled. If in doubt, ask your supervi-
sor.
1. If the vacuum is in its upright position (figure 1), raise the
handle while supporting the vacuum, then slowly lower the
vacuum to the floor.
2. Properly install the filter bag in the vacuum.
a. Lift the cover from the machine.
b. The filter bag inlet is designed with a rubber gasket that
fits securely over the bag adapter (figure 2) in the cover.
Push the filter bag inlet over the adapter on the cover.
Then from the outside of the cover, reach inside the
adapter and push the gasket on the rest of the way.
c. Replace the filter bag when full.
MACHINE OPERATION:
1. Plug the machine's power cable into a properly grounded
outlet (see Grounding Instructions).
2. The foot pedal should be raised to the "Brush" position
(figure 3, A) for wide area vacuuming.
3. Adjust the brush height with the lever located on the rear of
the machine near the floor (figure 3, B).
4. Turn the vacuum switch "ON" (rocker switch on operator's
right, figure 4, A).
5. Turn the brush switch "ON" (rocker switch on operator's left,
figure 4, B).
®
Clarke
Operator's Manual (EN) - Carpet Master 30
Figure 1
Bag Adapter
Adaptador de
la bolsa
Sac
Adaptateur
Brace
Abrazadera
Renfort
Figure 2
B
Figure 3
B
Figure 4
ENGLISH
EN
Cover Gasket
Junta de la cubierta
Joint du couvercle
A
A
- 5 -

Capítulos

Tabla de contenido
loading

Tabla de contenido