Safety Instructions; Warning Caution - Rotary SPO12 Standard Manual De Instrucciones

SAFETY
SAFETY
INSTRUCTIONS
INSTRUCTIONS
Do not operate
Proper maintenance
and inspection a damaged lift.
is necessary
for safe operation. c
SAFETY
CAUTION
INSTRUCTIONS
Authorized personnel
Read operating
only in lift area.
and safety manuals
before using lift.
©
WARNING
CAUTION
Use vehicle
Position vehicle
with center of gravity manufacturer's
midway between lift points.
adapters. ©
Do not override
self-closing
lift controls.
©
WARNING WARNING
Keep feet Remain clear of lift
when raising or
clear of lift
while lowering. lowering vehicle.
©
WARNING
WARNING
Clear area if vehicle
Avoid excessive
is in danger of falling.
rocking of vehicle
while on lift.
c

SAFETY INSTRUCTIONS

CAUTION
? ?
?
Lift to be used
by trained operator
only.
© ©
©
©
CAUTION
CAUTION
Always use
safety stands when
removing or installing
©
heavy components. ©
CAUTION
Auxiliary adapters
may reduce
load capacity.
©
©
2
• Daily inspect your lift. Never operate if it malfunctions or if it
has broken or damaged parts. Use only qualified lift service
personnel and genuine Rotary parts to make repairs.
• Thoroughly train all employees in use and care of lift, using
manufacturer's instructions and "Lifting It Right" and "Safety
Tips" supplied with the lift.
• Never allow unauthorized or untrained persons to position
vehicle or operate lift.
• Prohibit unauthorized persons from being in shop area while lift
is in use.
• Do Not permit anyone on lift or inside vehicle when it is either
being raised or lowered.
• Always keep area around lift free of tools, debris, grease and
oil.
• Never overload lift. Capacity of lift is shown on nameplate af-
fixed to the lift.
• Do Not stand in front of the lift or vehicle while it is being posi-
tioned in lift bay.
• Do Not hit or run over lift arms or adapters. This could damage
lift or vehicle. Before driving vehicle into lift bay, position arms
and adapters to provide unobstructed entrance onto lift.
• Load vehicle on lift carefully. Position lift adapters to contact
at the vehicle manufacturer's recommended lift points. Raise
lift until adapters contact vehicle. Check adapters for secure
contact with vehicle. Raise lift to desired working height.
DO NOT go under vehicle if locking latches are not engaged.
• Do Not block open or override self-closing lift controls; they are
designed to return to the "Off" or Neutral position
when released.
• Do Not remove or disable arm restraints.
• Remain clear of lift when raising or lowering vehicle.
• Always use safety stands when removing or installing heavy
components.
• Avoid excessive rocking of vehicle while on lift.
• Clear area if vehicle is in danger of falling.
• Remove tool trays, stands, etc. before lowering lift.
• Release locking latches before attempting to lower lift.
• Position lift arms and adapters to provide an unobstructed exit
before removing vehicle from lift area.