Loading And Changing The Cartridge Wedges Into The Magazine; Perpendicularity Adjustment (Valid For Machines With This Accessory Only) - Inmes IM-4P Manual De Intrucciones

Ensambladora

Tabla de contenido

Idiomas disponibles

7.2.1 - Loading and changing the cartridge wedges into the magazine

In order to fit the cartridges inside the machine just pull the spring loaded cable

as shown in Fig. 20. Then fit the cartridge inside the magazine as shown in Fig. 21 and

make sure the cartridge is sitting correctly inside the magazine and then release the

cable as shown in Fig. 22. In order to change the size of the wedges, first take out the

cartridge from the magazine and place the new cartridge according to your needs as

show in Fig. 19.

Fig. 20

This operation can be performed by turning clockwise or anticlockwise the proper

knobs 01 and 02 Fig. 23. It is very useful in those cases when the base of the moulding is

not perpendicular compared with the part of the moulding that leans against the fence.

The adjustable fence can be tilted +/- 2°. Before joining the moulding follow this

procedure:

Fig. 23

INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P

ENSAMBLADORA IM-4P

Fig. 21

a) Place the legs of the moulding against the

adjustable fence and set the vertical clamp

so that when pedal is depressed, they can

hold the moulding properly;

b) Press the pedal and check the quality of the

joint. In the case the joint is not good

release

the

perpendicularity of each fence by turning the

knobs 01 and 02 Fig. 23 and repeat the

operation over described above.

Fig. 22

pedal

and

adjust

the

Tabla de Contenido

Tabla de contenido