Leveling Bolts To Adjust The Height Of The Machine - Inmes IM-4P Manual De Intrucciones

to fill the lubricator glass to obtain good performance of the equipment. In order to
refill the lubricator glass proceed as follow:
a) Shut air supply 01 Fig. 08;
b) Unscrew the lubricator glass by turning clockwise direction, 02 Fig. 08 and 09;
c) Fill the lubricator glass with pneumatic oil, a little more than half glass;
d) Screw the lubricator glass back on making sure the O-ring is sitting correctly in the
housing.
Fig.10

6.4 - Leveling bolts to adjust the height of the machine

There are four leveling bolts to raise or lower the height of the machine
according to the customer preference. In order to make the height adjustment proceed
as follow:
a) Get someone help to tilt the machine;
b) Attach the leveling bolt 01 into the base as shown in Fig. 11;
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P
Fig. 08
The number of drops of pneumatic oil is adjusted
at the factory. It is usually not necessary to adjust
afterwards. We recommend that the user verify that
after every 25to30 action of the foot pedal, ONE drop
should fall. If it is necesary to adjust, proceed as
follow.
Using a screw driver turn clockwise the screw 01 Fig.
10 until it is it is completely closed. Then turn the
screw counterclockwise about ¼"until it reaches
the correct adjustment as mentioned above.
Fig.09
35